How to install a NA or NB Mazda Miata or MX-5 hardtop. In this video i show you how to fit the hardtop to a Mk1 or Mk2 Mazda Miata or MX-5. The hardtop for the Eunos roadster is also Brake kit. Because the MX-5 is exceptionally light, most people fit a set of upgraded performance pads to the stock braking system and call it a day. Some like to change the stock hoses for braided ones or fill the system up with performance fluid for a higher boiling point. If you track the car regularly and you’re running forced induction The first, pictured above, shows a PRHT that exactly mimics that on the outgoing Miata: Thick pillars and a single rear window. The other, also pictured, depicts the PRHT with a pair of tiny Holes were cut using tin snips (metal thin) and the shelf put back in place. The holes need to be nearer to the trim panel and front of the shelf so the speaker doesn't foul the fuel tank enclosure. Rule here is measure, measure and measure again before cutting. Then dynamat everything else. i have a 93 miata and i just picked up a hardtop. where are the main bolts to take off the soft top and how hard it is to put the hardtop on?? and where Remove the screw. Remove the rear deck lock cover. Loosen the plate installation bolts. Install the hardtop onto the car, fastening the front latch. Move the plate around until it sits tight against the rear deck bolt. Tighten the two plate bolts to between 18 and 26 Nm. Install the rear deck lock cover. Adjusting the front latch is similar to Next, remove the two screws on either front corner of the top that hold on the rubber corner seals. Put the top back up without latching it. On each side of the car, remove the three pieces of rubber seals that seal around the door windows. These pieces are held in by a pressure fit and should pull off easily. New Listing 1990-2005 Mazda Miata Oem Front Soft Hard Top Striker Plates Left Right 90-05. Pre-Owned. $40.00. Free shipping. MS41x.